open-discussion > SDMPsiGui Spontaneously Aborts After Editing Table
Showing 1-1 of 1 posts
Sep 3, 2019 12:09 PM | Michelle Sader
SDMPsiGui Spontaneously Aborts After Editing Table
Hello,
I have recently downloaded SDM for MacOS to use on pilot datasets. I had no trouble opening the GUI and setting up the path for the meta-analysis. When I attempted to save my finalized table via the SDM table editor, however, the GUI spontaneously aborted. From then on, I have been unable to get the GUI to open. When attempting to run the sdm in the terminal, I receive the following error message (attached below).
Having looked through the forums, it seems there was a bug in the program that occurred when tables were contained more columns than rows, but this is not the case with the datasets I am looking at.
I would be greatly appreciative of any insight to solve the issue.
Best,
Michelle Sader
I have recently downloaded SDM for MacOS to use on pilot datasets. I had no trouble opening the GUI and setting up the path for the meta-analysis. When I attempted to save my finalized table via the SDM table editor, however, the GUI spontaneously aborted. From then on, I have been unable to get the GUI to open. When attempting to run the sdm in the terminal, I receive the following error message (attached below).
Having looked through the forums, it seems there was a bug in the program that occurred when tables were contained more columns than rows, but this is not the case with the datasets I am looking at.
I would be greatly appreciative of any insight to solve the issue.
Best,
Michelle Sader