help > Does not appear in SPM Toolbox
Showing 1-5 of 5 posts
Jul 6, 2014 10:07 PM | Rowena Chin - UCL
Does not appear in SPM Toolbox
Hi,
I face a similar problem as with Sarah. I've downloaded the WFU_PickAtlas 3.0 and extracted the TAR in the SPM8 Toolbox folder. I see the three folders you've mentioned. However, when I open my SPM GUI in Matlab (R2013a), I am unable to see the WFU under the toolbox drop down. I did not add any new paths to the MATLAB directory. Not sure why this is happening, any insight would be great.
Best wishes,
Rowena
I face a similar problem as with Sarah. I've downloaded the WFU_PickAtlas 3.0 and extracted the TAR in the SPM8 Toolbox folder. I see the three folders you've mentioned. However, when I open my SPM GUI in Matlab (R2013a), I am unable to see the WFU under the toolbox drop down. I did not add any new paths to the MATLAB directory. Not sure why this is happening, any insight would be great.
Best wishes,
Rowena
Jul 7, 2014 12:07 PM | Benjamin Wagner - UT Southwestern Medical Center
RE: Does not appear in SPM Toolbox
Hi Rowena,
First confirm that you have the following paths:
spm/toolbox/wfu_pickatlas
spm/toolbox/wfu_tbx_common
spm/toolbox/wfu_results_viewer
Ben
First confirm that you have the following paths:
spm/toolbox/wfu_pickatlas
spm/toolbox/wfu_tbx_common
spm/toolbox/wfu_results_viewer
Ben
Jul 7, 2014 01:07 PM | Rowena Chin - UCL
RE: Does not appear in SPM Toolbox
Hi Ben,
I opened 'set paths' in MATLAB and only had the following:
spm8/toolbox/WFU_PickAtlas_3.0.4
Should I be adding the individual folders too?
I opened 'set paths' in MATLAB and only had the following:
spm8/toolbox/WFU_PickAtlas_3.0.4
Should I be adding the individual folders too?
Jul 7, 2014 01:07 PM | Benjamin Wagner - UT Southwestern Medical Center
RE: Does not appear in SPM Toolbox
Hi Rowena,
Take the sub-directories in WFU_PickAtlas_3.0.4 and move them into the spm8/toolbox directory. Then remove the WFU_PickAtlas_3.0.4 directory.
Ben
Take the sub-directories in WFU_PickAtlas_3.0.4 and move them into the spm8/toolbox directory. Then remove the WFU_PickAtlas_3.0.4 directory.
Ben
Jul 7, 2014 02:07 PM | Rowena Chin - UCL
RE: Does not appear in SPM Toolbox
Hi Ben,
Thanks - works OK now!
Best,
Rowena
Thanks - works OK now!
Best,
Rowena