help > Error in seed to voxel analysis: Source not found in global source list.
Showing 1-2 of 2 posts
Display:
Results per page:
Feb 12, 2019  02:02 AM | Gianpaolo Del Mauro
Error in seed to voxel analysis: Source not found in global source list.
Hello,

I am attempting to run a seed to voxel analysis, and I previously ran a ROI to ROI analysis with the same ROIs. Now, when trying to run the seed to voxel analysis, I am receiving the error message shown below in the second level analysis. 


ERROR DESCRIPTION:

Error using conn (line 7186)
Source aal.Hippocampus R not found in global source list. Please re-run first-level analyses
Error in conn_menumanager (line 120)
feval(CONN_MM.MENU{n0}.callback{n1}{1},CONN_MM.MENU{n0}.callback{n1}{2:end});
CONN v.17.f
SPM12 + DEM FieldMap MEEGtools cat12 conn
Matlab v.2016a
storage: 815.5Gb available
spm @ L:\spm12\spm12
conn @ L:\spm12\spm12\toolbox\conn17f\conn



When I try to enter the following command in the MATLAB window (recomended by Alfonso in a previous post):

global CONN_x CONN_x.Analyses(1).sourcenames=CONN_x.Analyses(1).source

and to run again the seed to voxel analysis, I am receiving this error message:

ERROR DESCRIPTION:

Error using spm_vol>spm_vol_hdr (line 80)
File "K:\CON-PCS-analysis\conn_project01\results\firstlevel\ANALYSIS_01\BETA_Subject001_Condition001_Source001.nii" does not exist.
Error in spm_vol (line 61)
v = spm_vol_hdr(deblank(P(i,:)));
Error in conn (line 7455)
CONN_h.menus.m_results.Y=spm_vol(char(filename));
Error in conn (line 6540)
if any(CONN_x.Analyses(CONN_x.Analysis).type==[2,3]), conn gui_results_s2v;
Error in conn_menumanager (line 120)
feval(CONN_MM.MENU{n0}.callback{n1}{1},CONN_MM.MENU{n0}.callback{n1}{2:end});
CONN v.17.f
SPM12 + DEM FieldMap MEEGtools cat12 conn
Matlab v.2016a
storage: 815.5Gb available
spm @ L:\spm12\spm12
conn @ L:\spm12\spm12\toolbox\conn17f\conn


Thank you immensely for the help,

Gianpaolo
Feb 18, 2019  02:02 AM | Rebecca Rebi
RE: Error in seed to voxel analysis: Source not found in global source list.
Hello,

I'm having the same problem.

I have a design with 5 conditions and entered them in the Setup step, but I'm interested in the connectivity matrix associated to each condition. However, when I try to run the first-level analysis doing exactly what Gianpaolo describes, I get to the same error. Any suggestions will be appreciated!

Sincerely,
VerĂ³nica