help
help > SBC analysis error following denoising
May 23, 2020 05:05 AM | jacobd - Columbia University
SBC analysis error following denoising
Hi experts,
I am attempting to extract default mode ROI-ROI connectivity data from a number of patients. Pre-processing and de-noising steps all look good, with positive QA results. However, following de-noising (when I open the 1st level analysis tab), I receive the following error only when attempting Seed-to-Voxel/ROI-to-ROI analyses:
Error using matlab.ui.control.UIControl/set
Error setting property 'Value' of class 'UIControl':
This is not a valid UIControlValue value. Value must be numeric.
Error in conn (line 6085)
set(CONN_h.menus.m_analyses_00{7},'value',CONN_x.Analyses(ianalysis).measure);
Error in conn_menumanager (line 134)
feval(CONN_MM.MENU{n0}.callback2{n1}{1},CONN_MM.MENU{n0}.callback2{n1}{2:end});
CONN18.b
SPM12 + DEM FieldMap LST MEEGtools cat12 conn suit vbm8
Matlab v.2017b
project: CONN18.b
This error does not pop up when I select voxel-to-voxel, ICA, or dyn-ICA tabs. As stated in the error code, I am using Matlab v.2017b and CONN 18.b. Is this a compatibility issue between the two? What else might be causing this error?
All help is very much appreciated. Thank you.
I am attempting to extract default mode ROI-ROI connectivity data from a number of patients. Pre-processing and de-noising steps all look good, with positive QA results. However, following de-noising (when I open the 1st level analysis tab), I receive the following error only when attempting Seed-to-Voxel/ROI-to-ROI analyses:
Error using matlab.ui.control.UIControl/set
Error setting property 'Value' of class 'UIControl':
This is not a valid UIControlValue value. Value must be numeric.
Error in conn (line 6085)
set(CONN_h.menus.m_analyses_00{7},'value',CONN_x.Analyses(ianalysis).measure);
Error in conn_menumanager (line 134)
feval(CONN_MM.MENU{n0}.callback2{n1}{1},CONN_MM.MENU{n0}.callback2{n1}{2:end});
CONN18.b
SPM12 + DEM FieldMap LST MEEGtools cat12 conn suit vbm8
Matlab v.2017b
project: CONN18.b
This error does not pop up when I select voxel-to-voxel, ICA, or dyn-ICA tabs. As stated in the error code, I am using Matlab v.2017b and CONN 18.b. Is this a compatibility issue between the two? What else might be causing this error?
All help is very much appreciated. Thank you.
Threaded View
Title | Author | Date |
---|---|---|
jacobd | May 23, 2020 | |
Alfonso Nieto-Castanon | May 23, 2020 | |
jacobd | May 23, 2020 | |
jacobd | May 23, 2020 | |