open-discussion
open-discussion > How to make spharm mesh without alignments
Jan 17, 2020 05:01 AM | Oh Jeongseok
How to make spharm mesh without alignments
Hello,
I tried making surface ssm with tibias. To apply this methods, I align all models before using SPHARM(picture on right).
However, while SPHARM module is running, the alignments were changed.
(the picture on the left is result of SPHARM module's doing alignment)
I tried to run with using registration templetes but the results were same.
So, I want to know if it can do SPHARM mesh generation without doing align again(suppose the models are all aligned already like picture on the right)
Thank you for read this question.
Regards,
Jeongseok
-----------------------------------
I just noticed there are discourse forum instead of here.
The same question is there, so please don't care about this question :)
I tried making surface ssm with tibias. To apply this methods, I align all models before using SPHARM(picture on right).
However, while SPHARM module is running, the alignments were changed.
(the picture on the left is result of SPHARM module's doing alignment)
I tried to run with using registration templetes but the results were same.
So, I want to know if it can do SPHARM mesh generation without doing align again(suppose the models are all aligned already like picture on the right)
Thank you for read this question.
Regards,
Jeongseok
-----------------------------------
I just noticed there are discourse forum instead of here.
The same question is there, so please don't care about this question :)