Hey there,

first of all: great software!

dcm2niix works fine, as long as I do not use option -n (e.g., -n 4) to convert single series. From the output written to the terminal, everything seems to run quite fine. I also get the message "Conversion required 6.709000 seconds", but no nifti-images are written to the output folder. As said, as long as I do not add option -n to command line, everything works as expected and nifti-output is received.

I am using dcm2niiX version v1.0.20250505 with dicoms acquired with Siemens syngo XA60. I should say that I use to operate dcm2niix via matlab (system('PathTo/dicm2niix.exe')

Hope, there is a solution?