Dear Conn Support,

Thank you for your hard work and dedication to this software! I am currently using Conn Toolbox to process longitudinal data for a clinical trial and have unfortunately run into an error during preprocessing. The error pops up as:

The following modules did not run:

Failed: Realign and Unwarp

Failed: Realign and Unwarp

Error using MATLABbatch system

Job execution failed. The full log of this run can be found in MATLAB command window, starting with the lines (look for the line showing the exact #job as displayed in this error message)

--------------------

Running Job #1

--------------------

Any suggestions on how to fix this would be greatly appreciated!

Thank you,

Durazzo Lab