Hi,

I have an issue about running CONN. I am using Scientific Linux 6, Matlab R2019a, SPM12 and CONN 19c, which I access via SPM's toolboxes. I tried to use CONN for 3 subjects, I have uploaded properly structural and resting data, including the right parameters. I have chosen the default processing pipeline, but it is frozen in the stage where I have to introduce the smoothing parameter. It is not doing anything, and I do not receive any error message. The space is enough. Do you have any suggestions?
Previously I have used CONN 17f and later 18b, but I did not have any problems for a while, afterwards 18b started freezing but in the end of results part.
Thank you very much in advance!


Best regards,
Anca